Aerco ProtoNode Gateway Rev 3 (with external LEDs) Instrukcja Użytkownika Strona 9

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 126
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 8
AERCO ProtoNode Gateway
User Manual
OMM-0080_0H AERCO International, Inc. 100 Oritani Dr. Blauvelt, NY 10913 Page 9 of 126
GF-129 Ph.: 800-526-0288 11/06/2014
2.4 DIP SWITCH CONFIGURATION
NOTE
The ProtoNode must be restarted after changes to DIP
switch settings in order for changes to take effect.
2.4.1 ProtoNode RER (DIP Switch A0A7): Setting the MAC Address for
BACnet MS/TP
Only 1 MAC address is set for the ProtoNode regardless of how many devices are
connected to it.
BACnet MS/TP MAC address between 1 to 127 are a Master Address and can be
auto-discovered by BAS front end systems that support Auto Discovery.
Address from 128 to 255 are Slave Addresses and can not be discovered by BAS
front ends that support auto discovery of BACnet MS/TP devices. Note: Never set a
BACnet MS/TP MAC Address from 128 to 255.
Set DIP switches A0 A7 to assign the MAC Address for BACnet MS/TP for the
ProtoNode RER (FPC-N34).
Please refer to Appendix A1 for the full range of addresses to set Node-ID/Device
Instance/MAC address.
FIGURE 2-1: MAC Address DIP Switches
NOTE
When setting DIP Switches, please ensure that power to the
board is OFF.
2.4.2 ProtoNode RER: Setting the Device Instance (Node-ID) for BACnet MS/TP
and BACnet/IP
The A Bank of DIP switches are also used to set the BACnet Device Instances.
BACnet/IP and BACnet MS/TP Addressing: The BACnet device instances will be set
by taking the Node Offset found in Web Configurator (Section 2.4.2.1) and adding it
to the value of the A Bank DIP switches (MAC address). When more than one
device is connected to the ProtoNode, the subsequent BACnet device instances will
be sequential. The BACnet Device Instance can range from 1 to 4,194,303.
For example:
o Node Offset (default) = 0 (see NOTE below)
o A Bank DIP Switch = 11
o Device 1 Device Instance = 50011
o To change the node offset see Section 2.4.2.1. The node offset can be changed
from 50000 to 1 to 4,194,302 via the Web Configurator.
Przeglądanie stron 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 125 126

Komentarze do niniejszej Instrukcji

Brak uwag