
AERCO ProtoNode Gateway
User Manual
OMM-0080_0H AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 Page 117 of 126
GF-129 Ph.: 800-526-0288 11/06/2014
Appendix D: C-More Status and Fault Messages
39
DIRECT DRIVE
SIGNAL FAULT
The direct drive signal is not present or is out of range.
40
REMOTE SETPT
SIGNAL FAULT
The remote setpoint signal is not present or is out of range.
41
OUTDOOR TEMP
SENSOR FAULT
The temperature measured by the Outdoor Air Sensor is out of
range.
42
The temperature measured by the Outlet Sensor is out of
range.
43
The temperature measured by the FFWD Sensor is out of
range.
44
The temperature measured by the Outlet Sensor exceeded the
Temp Hi Limit setting.
45
LINE VOLTAGE
OUT OF PHASE
The High AC voltage is out of phase from the low AC voltage.
46
The stepper motor failed to move the valve to the desired
position.
47 SETPT LIMITING ACTIVE
Setpoint temperature has exceeded the maximum allowable
setting.
48 MODBUS COMM FAULT
The RS485 (Modbus) network information is not present or is
corrupted.
Pause before retrial for ignition.
52
EXHAUST TEMP SENSOR
SHORT
Exhaust temperature sensor is shorted.
53
Exhaust temperature sensor is open or missing.
54
WARNING EXHAUST
TEMP HIGH
Exhaust temperature is getting high.
Exhaust temperature is too high.
56
INLET WATER TEMP
SENSOR SHORT
Inlet water temperature sensor is shorted.
57
INLET WATER TEMP
SENSOR OPEN
Inlet water temperature sensor is open or missing.
Komentarze do niniejszej Instrukcji