Aerco ProtoNode Gateway Rev 3 (with external LEDs) Instrukcja Użytkownika Pobierz pdf (Strona 21)

AERCO ProtoNode Gateway

User Manual

OMM-0080_0H AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 Page 21 of 126

GF-129 Ph.: 800-526-0288 11/06/2014

3.8 AERCO C-More Controller PMC Board DIP Switch Settings

The RS485 DIP switches (S1 bank) on the C-More controller PMC PCB must be configured

properly for use with a ProtoNode. The PMC PCB is accessed by removing the four Phillips

screws at the corners of the C-More Controller front panel. The PCB is mounted on the inside of

the front cover as shown in Figure 3-11.

3.8.1.1 Accessing the PMC Board in the C-More Controller

WARNING!

Shut off electrical power upstream of the boiler before

opening the C-More controller to avoid the danger of

electrical shock.

FIGURE 3-11: Location of RS-485 DIP Switch on C-More PMC PCB

CAUTION

The C-More Boiler Controller Printed Circuit Boards contain

electronic components that are sensitive to electrostatic discharge

(ESD). Prior to performing the following steps, put on an anti-

static wrist strap and connect the clip lead to earth ground.

Failure to observe this precaution may result in permanent

damage to on-board ESD-sensitive components.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 125 126

Brak uwag

Aerco ProtoNode Gateway Rev 3 (with external LEDs) Instrukcja Użytkownika Strona 21